★★★★★
"Kamdem is an expert and makes sure everything is safe and working properly. He serviced our gas fire and found a problem we did not know about. Cannot fault him — we will be using him every year from now on."
Professional Gas Fire Servicing in Manchester & Greater Manchester
Annual gas fire servicing for all fire types. Gas Safe registered engineers. Safety inspections, fault diagnosis, and repair across Greater Manchester.
🛡 Gas Safe Reg: 559988 · 18+ Years Experience · Same-Week Available · Fully Insured
What Does Gas Fire Servicing Involve?
Gas fire servicing covers the annual inspection, safety testing, and maintenance of all types of domestic gas fires — including conventional open-flue gas fires, balanced flue gas fires, inset gas fires, slimline gas fires, freestanding gas stoves, and flueless gas fires installed under current Building Regulations. Annual servicing is recommended for all gas fires and is mandatory for any gas fire in a rented property as part of the landlord CP12 inspection.
A Kamdem HomeTech gas fire service includes:
- Visual inspection of the entire fire body, casing, burner, controls, and any glass or ceramic front panel — identifying damage, deterioration, or signs of incorrect operation
- Flue inspection and test — for open-flue gas fires, we carry out a flue flow test to confirm that combustion products are being correctly exhausted and that the flue is clear of obstruction. For balanced flue fires, we inspect the terminal and the sealed flue for correct operation
- Combustion analysis — measuring flue gases where accessible to confirm the burner is operating within safe combustion parameters
- Burner clean — removal and cleaning of the burner and pilot assembly; removal of accumulated combustion deposits that reduce efficiency and may cause ignition problems
- Pilot assembly inspection and clean — pilot jets, thermocouples, and flame supervision devices are cleaned, inspected, and tested
- Refractory inspection — checking the condition of the coals, logs, pebbles, or other refractory components that are designed to distribute heat and may deteriorate over time. Damaged refractory must be replaced to maintain safe combustion
- Safety control test — testing the flame supervision device (FSD) / thermocouple that cuts off the gas supply if the flame is extinguished, and any overheat protection fitted to the appliance
- Ventilation check — confirming that the room has adequate ventilation to provide combustion air for the fire type and rating
- Written service record — issued on completion, documenting all work carried out and the outcome of all safety tests
Gas fire repairs are also carried out following diagnosis: thermocouple and flame supervision device replacement, pilot assembly replacement, gas valve and control unit replacement, ignition system repair, and refractory component replacement. We advise honestly when a gas fire has reached end of life and replacement is the more economical option — recommending replacement only when it genuinely is.
What Happens When You Delay?
An unserviced gas fire is the most significant source of domestic carbon monoxide incidents in UK homes. The risk is not theoretical — every winter in the UK, people are hospitalised or killed by carbon monoxide produced by faulty, unserviced gas fires. The mechanism is straightforward: an unserviced fire accumulates combustion deposits on the burner and pilot assembly, its flue becomes partially blocked with debris, and the result is incomplete combustion — producing carbon monoxide instead of the inert CO₂ that a correctly operating fire produces.
Carbon monoxide is colourless, odourless, and tasteless. Without a working CO alarm, its accumulation in a room is undetectable until exposure symptoms develop — headache, nausea, confusion — at which point incapacitation may prevent escape. It kills people in their sleep. An annual gas fire service, combined with a functioning carbon monoxide alarm, is the only reliable protection.
Beyond the life-safety risk, an unserviced gas fire operates at reduced efficiency — a partially blocked burner consumes more gas to produce less heat, adding 15–30% to your gas bill for that appliance. Annual servicing costs a fraction of this wasted expenditure and provides documented evidence of maintenance for your home insurer.
Use your gas fire this winter. But have it serviced first.
Our Process — Simple, Transparent, Reliable
02
Free Diagnosis & Quote
Clear fixed-price quote with no obligation.
03
Engineer Dispatched Fast
Qualified Gas Safe engineer — usually within the hour.
04
Expert Work Carried Out
Clean, methodical workmanship by certified engineers.
05
Job Done & Guaranteed
We clean up and guarantee every job we complete.
Why This Matters For You
Carbon Monoxide Safety
Annual gas fire servicing — combined with a working CO alarm — is the only reliable protection against carbon monoxide production from a faulty or deteriorating gas fire. This is not a compliance checkbox; it is a genuine life-safety measure.
Gas Safe Registered
All gas fire servicing and repair is carried out by Gas Safe registered engineers (Reg: 559988) — the legal requirement for all gas appliance work in the UK.
All Gas Fire Types Covered
Open-flue, balanced flue, inset, freestanding stove, flueless — we service and repair all domestic gas fire types installed across Greater Manchester.
Honest Advice on Repair vs Replacement
We carry common gas fire spare parts and repair wherever it is economical. If a fire is beyond economic repair, we will tell you honestly — not recommend an unnecessary replacement.
Landlord CP12 Scope
Gas fires in rented properties must be inspected as part of the annual Gas Safety Certificate (CP12). We can carry out the full CP12 inspection and gas fire service in a single visit — see our landlord gas safety page for portfolio management details.
Written Record for Insurer
Your home insurer may require evidence of annual gas fire servicing in the event of a claim involving the fire or its flue. Our written service record provides this documentation.
Frequently Asked Questions
How often should a gas fire be serviced?
Every 12 months without exception. Annual servicing is required for landlord CP12 compliance, recommended by all gas fire manufacturers, and the only reliable way to ensure the fire is safe before use.
When is the best time to have my gas fire serviced?
September or October — before the heating season begins. Having your fire serviced before you first use it in autumn ensures any developing faults are found when they can be resolved, not when the fire is in daily use.
My gas fire won't light — is that a service issue or a repair?
An ignition failure is almost always a repair — typically a thermocouple or flame supervision device failure, or a pilot assembly fault. We can diagnose and repair all common gas fire ignition failures across Greater Manchester. Call us on 07826 088938.
What is a thermocouple and why does it fail?
A thermocouple is a safety device that generates a small electrical current when heated by the pilot flame, signalling to the gas valve that it is safe to remain open. Over time — typically 5–8 years — thermocouples deteriorate and produce insufficient current to hold the gas valve open, causing the fire to shut off shortly after ignition. Thermocouple replacement is one of the most common gas fire repairs and is usually completed in a single visit.
My gas fire produces a yellow/orange flame rather than blue — is that a problem?
Yes. A gas fire with a predominantly yellow or orange flame is burning incompletely — indicating a burner problem, blockage, or incorrect gas pressure. This is a safety issue as incomplete combustion produces carbon monoxide. Turn the fire off and call Kamdem HomeTech on 07826 088938.
Do I need a carbon monoxide alarm if I have a gas fire?
Yes. A CO alarm is strongly recommended and in most local authority areas is a legal requirement in rooms where gas appliances operate. A 10-year sealed carbon monoxide alarm costs less than £20 and may save your life. Ensure yours is in date and functional.
Can you service a gas fire that was installed by a previous owner and has no service history?
Yes. A fire with no service history is one of the most important ones to service — precisely because you don't know its condition. We carry out a thorough inspection regardless of the appliance's history. Where the fire has developed serious safety faults, we will advise honestly on whether repair or replacement is the appropriate course.
Are gas fires in rental properties covered by the CP12 inspection?
Yes. All gas fires in rented properties must be inspected as part of the annual Gas Safety Certificate (CP12). We include all gas fires in the scope of every CP12 inspection. For full landlord compliance details, see our landlord gas safety page.
Ready to Get Started?
Call Kamdem HomeTech or submit the online form. We respond within 2 hours.
⭐ 4.8-Star Rated · Gas Safe · Fully Insured